AEM V3 1 Gallon Water/Methanol Injection Kit AEM Electronics

The AEM Water Injection Kit is a cost effective and user-friendly alternative to very expensive water injection kits. The AEM Water Injection kit is a perfect way to reduce air inlet temps and increase charge density in boosted vehicles. This AEM kit allows the user to safely run higher boost pressures and suppress detonation allowing the utilization of more timing and boost. AEM’s progressively controlled high-pressure pump draws water (or up to a 50% alcohol mixture) from the one gallon tank with integral fluid level sensor to provide boost-dependent variable flow.

Part #: 30-3300

Your water is fed into the intake system via interchangeable nozzles for additional flow control. An integrated system status light mounts on your dash will keep you informed with easily identifiable error codes that include short circuit warnings, battery voltage problems, and low fluid alarms. AEM also incorporated a failsafe that provides output to either decrease timing, or reduce boost if the system runs out of fluid or detects any error.

Complete kit includes: One gallon tank with integral fluid level sensor. Progressive control 150 PSI pump. Three different size jets. Dash mountable warning light. All hardware & hoses for installation.

Not CARB Legal: Not for sale or street use in CA & CARB states.

This item is non application specific. Please verify compatibility before purchase. May require some modification for proper installation.

NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY EMISSION CONTROLLED MOTOR VEHICLE.