GSC P-D Chrome Polished Intake Valve 36mm Head (+1mm) – Honda K Series Vtec (Set 8) GSC Power Division

Part #: 2044-8

When designing these valves, GSC used advanced 3D design and simulation programs to create a stronger and higher flowing valve head design. Prototypes were used in the specific applications to make sure that they have the highest flowing valve head that is available on the market today. The materials they have used have less valve distortion at the face than any of the tested designs which allow for better sealing under extreme conditions to promote more consistent performance through the life of the valve.

Here are more key features:

Valve Features:

Swirl polished heads for smoother airflow over the valve

Back cut to reduce valve weight for higher rpm, higher boost pressure and allow for more aggressive cam profiles without increasing valve spring seat pressures.

Valve stems are micro-polished to allow for less oil retention on the stem which creates less drag on the stem to guide for a smoother motion.

Fully nitrated ( this includes the 45 which increases valve life and makes a better seal at the valve seat for improved cylinder pressure) also reduces carbon buildup on the backside of the valve.

Intake valves are a modified 21-4n stainless and Exhausts are a modified 23-8n stainless material for high heat capacity while maintaining longevity.

Valve tips are either hardened or have a stelite wafer tip fused so that the tip is within 5 Rockwell C of the rocker or valve tappet for extended life and less wear

Valve tip lengths. They have taken extra time to adjust tip heights on the applications to require less tipping of the valve to maintain proper tip height for proper valvetrain geometry and to cut down on install times when setting valve lash.

They have also adjusted the Keeper grove to properly balance intake and exhaust spring pressures to reduce the use of valve spring shims and maximize performance from their spring and retainer kits.

Valves will work with an OEM keeper/lock or when available their upgraded keeper/lock. It’s not mandatory but it is suggested that any valve lock not be reused on performance applications due to material grooving.

Here are more key features:

Valve Features:

Swirl polished heads for smoother airflow over the valve

Back cut to reduce valve weight for higher rpm, higher boost pressure and allow for more aggressive cam profiles without increasing valve spring seat pressures.

Valve stems are micro-polished to allow for less oil retention on the stem which creates less drag on the stem to guide for a smoother motion.

Fully nitrated ( this includes the 45 which increases valve life and makes a better seal at the valve seat for improved cylinder pressure) also reduces carbon buildup on the backside of the valve.

Intake valves are a modified 21-4n stainless and Exhausts are a modified 23-8n stainless material for high heat capacity while maintaining longevity.

Valve tips are either hardened or have a stelite wafer tip fused so that the tip is within 5 Rockwell C of the rocker or valve tappet for extended life and less wear

Valve tip lengths. They have taken extra time to adjust tip heights on the applications to require less tipping of the valve to maintain proper tip height for proper valvetrain geometry and to cut down on install times when setting valve lash.

They have also adjusted the Keeper grove to properly balance intake and exhaust spring pressures to reduce the use of valve spring shims and maximize performance from their spring and retainer kits.

Valves will work with an OEM keeper/lock or when available their upgraded keeper/lock. It’s not mandatory but it is suggested that any valve lock not be reused on performance applications due to material grooving.